Epson E03 PAB Usb+ Network Branded used printer

The Epson UB-E03 (sometimes referenced as E03 PAB 03) is an Ethernet interface board that upgrades Epson TM-series point-of-sale (POS) printers with network connectivity. It seamlessly integrates into models that support UB-type swappable interfaces Epson SupportHillside Electronics Corp..

Key Features & Capabilities

• Network Connectivity: Supports 10Base-T and 100Base-TX Ethernet, with full or half duplex and Auto-MDIX functionality Epson DownloadsEpson Support.

• Protocols Supported: Compatible with TCP/IP, including ICMP, UDP, IP, LP/LPR (for printing), and raw socket communication (often on port 9100) Epson SupportEpson Downloads.

• Network Setup Options:

  • DHCP support for dynamic IP assignment.

  • APIPA for automatic addressing if DHCP isn’t available.

  • Manual IP configuration via utility or ARP/PING commands Epson DownloadsEpson Support.

• Management & Monitoring:

  • SNMP support allows printer status monitoring and management.

  • A small built-in web server (using HTTP) facilitates configuration via a browser Epson Downloads.

• Power Efficiency: Features a low-power consumption mode that activates when idle, resuming full operation upon incoming communications or user interaction Epson DownloadsSHI Public Sector.

• Firmware Updates: Can be updated directly over the network Epson Downloads.

How to Install & Configure

• Installation:

  1. Power off the printer and disconnect it from the power supply.

  2. Remove any existing interface board.

  3. Mount the UB-E03 board using the existing screws.

  4. Attach an RJ-45 Ethernet cable to the connector.

  5. Reconnect power and turn on the printer Epson SupportEpson Downloads.

• Configure Settings:

  • Epson TMNet WinConfig utility (Windows) helps discover and set IP, subnet, gateway, etc. Epson Downloads.

  • Web browser: Navigate to http://<device-ip>/ to adjust settings using TMNet WebConfig Epson Downloads.

  • Push-button on the board:

    • Hold for ~3 seconds to print a status/configuration sheet.

    • Hold while powering on for ~10 seconds to reset to factory defaults. Epson Downloads.

• Advanced Options:

  • You can also initialize the board using ARP and PING commands to assign or change IP address Epson Downloads.